Kaseya Community

Server hangs at blinking cursor after BUDR using UR

  • Older Gateway PATA IDE based server to new HP Proliant ML110 G5 using onboard RAID and SATA disks. The old server just has basic disks, no dynamic disks.

    After doing a universal restore the new server stops just before starting to boot windows with the flashing cursor in the top left corner.

    We have done the restore both with and without the MBR and gone into the recovery console and done a fixboot /mbr

    any ideas?

    Legacy Forum Name: Server hangs at blinking cursor after BUDR using UR,
    Legacy Posted By Username: trebligb
  • When you were setting up the restore in UR, did you make sure to specify the raid controller drivers and provide them?

    Legacy Forum Name: BU-DR,
    Legacy Posted By Username: boudj
  • boudj
    When you were setting up the restore in UR, did you make sure to specify the raid controller drivers and provide them?


    Yep, even was on the phone with HP to verify we had the right driver after it failed the first time.

    Legacy Forum Name: BU-DR,
    Legacy Posted By Username: trebligb
  • Stange... I usually see that with Raid drivers being incorrect. How about using the convert to VM?

    Legacy Forum Name: BU-DR,
    Legacy Posted By Username: boudj