After doing a Network Discovery of our local lan, I was happy to see that all of the ports were found and monitors were created for each. Upon looking down the list however, it seems that there is a redundancy?
What's the difference between "Bandwidth":
and "Bandwidth util":
Different methods to get the same data? Is one better than the other? Or is this just a goof that double assigns the same monitor with different names?
KNM will preconfigure bandwidth and bandwidth utilization monitors for each port of the switch. The difference is that the "Bandwidth" monitor will show utilization in kbps, mpbs or gbps while the "Bandwidth util." monitor will show utiliazation in percent (calculated from the available speed of the port).
Quality Assurance Engineer